Skip to content

MakeCode package for 4tronix Cube:Bit RGB Cubes

License

Notifications You must be signed in to change notification settings

4tronix/CubeBit

Folders and files

NameName
Last commit message
Last commit date

Latest commit

 

History

17 Commits
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

Repository files navigation

MakeCode Package for 4tronix Cube:Bit Magical RGB Cubes of Awesome

Helper routines for using the Fireleds in the 4tronix Cube:Bit range of Cubes

Defining the Cube

The first thing you should do is create a Cube object with the required dimensions per side using the create(...) function. This example creates a 4x4x4 cube on Pin 0:

cubebit.create(DigitalPin.P0, 4)

Then set the brightness to be used (values from 0 to 255) using the setBrightness(...) function. If this block is not used, then the brightness is set to 40. We strongly recommend keeping this at less than 100. All values sent to the LEDs after this command will be scaled down to fit in this maximum brightness level.

This example sets the brightness to 80:

cubebit.ledBrightness(80)

Using Cube:Bit Fireleds

Each Fireled can be addressed by using the ID which is a number from 0 to the number of pixels in the cube minus one. For example, a 3x3x3 cube has 27 pixels so the ID can be 0 to 26, 4x4x4 has 64 (ID 0 to 63) and 5x5x5 has 125 (ID 0 to 124)

Set the Fireled at ID 37 to Green:

cubebit.setPixelColor(0, 0xFF0000)

The colour value is a number. There are some pre-define colours (eg. Red, Yellow, etc) or you can put in a simple number, or you can define separate Red, Green and Blue values using the convertRGB(...) map colour block. This example sets Fireled 41 to colour: Red to 25, Green and Blue to 50:

cubebit.setPixelColor(41, cubebit.convertRGB(25, 50, 50))

If you want to specify the x,y,z position of the pixel then use the mapPixel(...) block to create the pixel ID. The x, y and z values must be less than the number of Fireleds per side.

This example sets the Fireled at position x=2, y=3, z=1 to a Purple colour:

cubebit.setPixelColor(cubebit.mapPixel(2, 3, 1), 0xFF00FF)

If you have set the Manual update mode, then whenever changing the colour of pixels or clearing them, or rotating them, you will need to display the result afterwards. Use the ledShow(...) block for this. The default update mode is automatic so any changes to the LED values will immediately appear on the LEDs

cubebit.ledShow()

You can also set a whole plane of pixels to the same colour. eg. set the top slice to blue, or the left side to green. Use the setPlane(...) block.

This example sets Plane 1 on the XZ axis to Blue:

cubebit.setPlane(1, CBAxis.XZ, 0x0000FF)

Supported targets

  • for PXT/microbit

License

MIT

About

MakeCode package for 4tronix Cube:Bit RGB Cubes

Resources

License

Stars

Watchers

Forks

Packages

No packages published