Add new options for Artnet / sACN

[Bauteiltoeter]

This PR adds two new options to the available options for sACN / Artnet Interface.

The two new options make it possible to use Artnet to switch between Preset selection and and pixel-control.
For this the first channel is used.
If channel 1 is between 0 and 126 WLED is in Preset mode.
In this case:
Channel 2: Preset ID
Channel 3: Brightness

If channel 1 is between 127 and 255 WLED is in direct pixel mode (RGB or RGBW).
In this case:
Channel 2-4: unused
Starting from channel 5: RGB / RGBW pixel data.

[blazoncek]

Please rebase your PR for 0_15 branch.

[netmindz]

It's rather unusual for a dmx fixture to change it's whole personality based on a dmx value, that's what RDM is for.

If we were to make this change then it would be nice if we could handle all possible modes than just preset/rgb

[Bauteiltoeter]

I didn't see it as "changing the personality" (which in fact is unusual), but I see it as "integrated effect" vs "cell / pixel mode."
There are a lot of fixtures that have an macro channel / mode (brightness + internal effect type) additional to the single cell access. This is why I implemented the switch between "single cell" and "predefined effects".

I'll have to rebase this PR which is a bit of a pain because of the autogenerated files.

[blazoncek]

I'll have to rebase this PR which is a bit of a pain because of the autogenerated files.

0_15 no longer tracks autogenerated files.