diff --git a/content/cumulus-linux-512/System-Configuration/Date-and-Time/Precision Time Protocol-PTP.md b/content/cumulus-linux-512/System-Configuration/Date-and-Time/Precision Time Protocol-PTP.md
index 548ac959c1..e68e6ac6f5 100644
--- a/content/cumulus-linux-512/System-Configuration/Date-and-Time/Precision Time Protocol-PTP.md	
+++ b/content/cumulus-linux-512/System-Configuration/Date-and-Time/Precision Time Protocol-PTP.md	
@@ -173,7 +173,7 @@ cumulus@switch:~$ nv config apply
 {{%notice note%}}
 - You can configure only one address; either IPv4 or IPv6.
 - For IPv6, set the trunk port transport mode to IPv6.
-- Layer 2 and layer 3 PTP transport cannot co-exist.
+- Layer 2 and layer 3 PTP transport cannot coexist.
 - When you configure PTP layer 3 transport, you must configure:
   - An SVI for VLAN-based routing.
   - A base interface configuration to ensure proper packet forwarding.
@@ -220,7 +220,7 @@ cumulus@switch:~$ nv config apply
 - You can configure only one address; either IPv4 or IPv6.
 - For IPv6, set the trunk port transport mode to IPv6.
 - When you enable PTP on a bridge port, you must also enable PTP on the VLAN configured for the port with the `nv set bridge domain <domain> vlan <vlan-id> ptp enable on` command.
-- Layer 2 and layer 3 PTP transport cannot co-exist.
+- Layer 2 and layer 3 PTP transport cannot coexist.
 - When you configure PTP layer 3 transport, you must configure:
   - An SVI for VLAN-based routing.
   - A base interface configuration to ensure proper packet forwarding.