rfcodesDocumentation

//RF codes for RF wireless outlets from amazon
//similar to these: http://www.amazon.com/Etekcity%C2%AE-Wireless-Controlled-Electrical-Included/dp/B0087DAW46/ref=sr_1_2?ie=UTF8&qid=1377965136&sr=8-2&keywords=wireless+outlet

uint32_t _CMD_1 = 0b1111111101010101110000010; 
uint32_t _CMD_2 = 0b1111111101010101001100010;
uint32_t _CMD_3 = 0b1111111101010101000011010;
uint32_t _CMD_4 = 0b1111111101010101111111010;


//Belkin RF switch
//similar to this: http://www.amazon.com/Belkin-Conserve-Switch-Energy-Saving-Protector/dp/B003P2UMNK/ref=sr_1_17?ie=UTF8&qid=1377965373&sr=8-17&keywords=belkin+wireless+outlet

//ON CODE
uint32_t _CMD_2 = 0b0100000101010101001100010;
//OFF CODE
uint32_t _CMD_3 = 0b0100000101010101110011100;

//RF transmitter fire function this is for the pt2262 RF encoder - written for arduino

static void pt2262Send(uint32_t command) {
  	byte ix, kx;
  
        Serial.println(command, BIN);
        Serial.println();
  	// ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
  	// Send the series 16 times
  	//
  	for(byte kx = 0; kx < 16; kx++) 
        {
      	    // ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
            // Send 16 bits for the Control/Signature sequence
            // Send  8 bits for the Command sequence
            // Send  1 bit for the trailing zero
            // Send a total of 25 bits
            //
    	    for(ix = 7; ix < 32; ix++) 
            {
  		// If the bit is on, send a '1'
    	        digitalWrite(sendPin, HIGH);
	        delayMicroseconds(160+((command >> (31 - ix) & 0x01)*2*160));
	        digitalWrite(sendPin, LOW);
	        delayMicroseconds(160+(!(command >> (31 - ix) & 0x01)*2*160));
            }

    	    // short delay
    	    delay(5);
  	}  // End Outer FOR loop
  
        for(ix = 7; ix < 32; ix++) {
              Serial.print("HIGH for ");
              Serial.print(160+((command >> (31 - ix) & 0x01)*2*160));
              Serial.print("us - LOW for ");
              Serial.print(160+(!(command >> (31 - ix) & 0x01)*2*160));
              Serial.println("us");
        }
}