-
Notifications
You must be signed in to change notification settings - Fork 942
Variant NUNCHUK
Candas1 edited this page Apr 16, 2021
·
17 revisions
This variant can be used with Wii Nunchuk (not the Wiimote).
- Connect blue wire to SCL and green wire to SDA on right sensor board cable(shorter)
- ⚠ 100k Pull up resistors connected to 3.3v are recommended to prevent the board to go full speed if nunchuk is disconnected
| SCL | -- | 3.3v |
|---|---|---|
| GND | -- | SDA |
Recommendation: Nunchuk Breakout Board https://github.com/Jan--Henrik/hoverboard-breakout
⚠ Red wire from sensor cable delivers 15v !!! Use 3.3v from programming port or a voltage regulator.
Proceed with calibration for better control.
If the board is beeping
- On some boards the wire colors might differ, try switching blue and green cable
- Keep cable short, use shielded cable, use ferrits, stabilize voltage in nunchuk