Installed 1.3.3.8 and installed the K1 scripts now Klipper won't start

[K2AAE]

{"code": "key341", "msg": "Section 'server' is not a valid config section\n\nOnce the underlying issue is corrected, use the "RESTART"\ncommand to reload the config and restart the host software.\nPrinter is halted\n", "values": ["server"]}

I've been thru every file in /usr/data/printer_data/config/ - found one Server section in moonraker.conf, commented it out still the same error.

I let Creality 'upgrade' to 1.3.3.8, had to use the complete reinstall method to get rid of the old crap, works now.

[Guilouz]

After updating firmware you must reset to factory settings.

[K2AAE]

When I said it was running, that was the new firmware after a complete reset, it worked until I ran the script, installed items: 1,2,4,5,14,6 and now I get:
{"code": "key341", "msg": "Section 'server' is not a valid config section\n\nOnce the underlying issue is corrected, use the "RESTART"\ncommand to reload the config and restart the host software.\nPrinter is halted\n", "values": ["server"]}

Again.

Ok, here is what caused that: After installing 1 ~ 6 + 14 I opened the browser and was told moonraker was not running, I added moonraker.conf to the printer.cfg as an include. I just removed it and the error above disappeared. So, Install firmware, hard reboot, install script, hard reboot. Hard reboot = power cycle

[TheWebMachine]

Sorry...that was supposed to post as a new discussion...not sure how it ended up here. 🤦🏻‍♂️

[GrandpaJ152]

i just did the root on a K1 Max and works great