FlatCam Comments

[chbi4456]

"It is recommended to reduce Feedrate Z to 60 (300 may be too high and could cause damage to the board). Adjust Cut Z to a value that will completely drill through the board. If using the provided fixture, there will be ample clearance under the board."

Is there a standard Cut Z that you could add? It would at least be helpful to know what you usually put.

[chbi4456]

"In FlatCAM, open the Gerber and the Excellon files to add them to the FlatCAM project."

For me, KICad generates several extra excellon and gerber files. It would be helpful to add some directions on which files to use more specifically.