Problems with Printer.cfg

[lucasromeiro]

Hi, i install my Klipper with your instruction.

I had some problems with the PRINTER.CFG file.
1- The table size is wrong on one of the axes the table is 235X235.
2- The current in the motors is 1.2A, this overheated my motors, it would be good to adjust to 0.8mA.
3- Noise in the engines (I'm still checking how to solve it).

Something else can be improved/adjusted in the PRINTER.CFG file

[JoeTodes]

The actual printable area is ~230mm in both axes, and the x-limit switch is about 4mm off the bed so the size gets offset by 4 as well