From 7a007c38662c256cb0693b8a0af7cae63aff48ac Mon Sep 17 00:00:00 2001 From: Andy Lewis Date: Sat, 2 Nov 2024 14:20:26 -0500 Subject: [PATCH] Update versa_usage2.html Additional updates adding more usage details. --- share/qtvcp/widgets_ui/versa_usage2.html | 24 ++++++++++++++++-------- 1 file changed, 16 insertions(+), 8 deletions(-) diff --git a/share/qtvcp/widgets_ui/versa_usage2.html b/share/qtvcp/widgets_ui/versa_usage2.html index e8a90ea0e15..6a6c46bff5e 100644 --- a/share/qtvcp/widgets_ui/versa_usage2.html +++ b/share/qtvcp/widgets_ui/versa_usage2.html @@ -9,9 +9,11 @@ Versa Probe Usage (pg2) -

Versa Probe Usage (pg2)

-

DIAMETER

-

This is the diameter of the probe tip. The accuracy of probe measurements is directly affected by the accuracy of the probe tip diameter.

+

Versa Probe Usage (page 2)

+

INPUT (read-only)

+

Defines the unit type of the current configuration.

+

DIAMETER

+

This is the diameter of the probe tip. The accuracy of probe measurements is directly affected by the accuracy of the probe tip diameter.

TRAVEL (velocity)

The distance that the probe will travel during the initial search. If the search distance is too short, you will receive a message like "G38 finished without making contact". For safety reasons, it is recommended to set this parameter to 3-4 mm more than probe stylus diameter.

LATCH RTN (latch retract)

@@ -32,12 +34,18 @@

The distance that the probe will move away from an edge or corner before performing a search. It should be large enough to ensure that the probe will not contact the workpiece or any other fixtures before moving down. It should be small enough to avoid excessive waiting for movement while searching.

Z (clearance)

The distance that the probe will move down before performing a search. If measuring an inside hole, the probe could be manually jogged to the starting Z height and then set Z CLEARANCE to 0.

-

There are three toggle buttons:

-

AUTO ZERO

-

If selected, after probing the relevant axis will be set to ZERO in the current user system.

-

AUTO SKEW

-

If selected, after probing the system will be rotated or just display the calculated rotation.

+

MOTION TYPE (read-only)

+

Indicates motion state when probing is active(real-time)

+

There are three toggle buttons:

TOOL MEASURE

Tool measure, if integrated, turns auto tool probing on and off.

+

AUTO SKEW

+

If selected, after probing the system will be rotated or just display the calculated rotation.

+

AUTO ZERO

+

If selected, after probing the relevant axis will be set to ZERO in the current user system.

+

Probe Type

+

Clicking the probe type button cycles or round-robins through the different probe type options.

+

Set Angle

+

Set Angle used in the skew pane.


\ No newline at end of file