[BUG] (short description) Ender 5 Plus Bigtree SKR 3 configuration needs README update to point to correct display firmware.

[nmedward]

Did you test the latest bugfix-2.1.x code?

Yes, and the problem still exists.

Bug Description

The latest version of the DGUS Reloaded display driver does not work with the 2.1.2.5 (and likely older configs). If you use that version of Marlin with the version of the display firmware pointed to in the README the temperatures will read off by 10x. So it will read as 2.2 C when it should be 22 C. I am not sure where the zip for the previous version of the driver is or I would make a PR to update it in the documentation.

Bug Timeline

Started with latest update to DGUS Reloaded

Expected behavior

I think either a link to an older compatible display firmware version or a note about the issue in the readme would be sufficient. The updates in that latest version of the firmware are awesome and in my opinion it is best to just go to the bugfix version.

Actual behavior

The instructions lead the user to using an incompatible versions that are tricky to debug.

Steps to Reproduce

Build the provided config for the Ender 5 plus with Marlin 2.1.2.5 using the original display as described in the readme.

Version of Marlin Firmware

2.1.2.5

Printer model

Ender 5 plus

Electronics

BTT SKR 3 EZ

LCD/Controller

DWIN T5UID1

Other add-ons

No response

Bed Leveling

None

Your Slicer

None

Host Software

None

Don't forget to include

• A ZIP file containing your Configuration.h and Configuration_adv.h.

Additional information & file uploads

Config was updated for my stepper drivers and the SKR EZ mainboard.
Configuration.zip