You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
The slicer should not only be smart enough not to heat an extruder that will not be used (as all others do), but it should also be smart enough to begin cooling down an extruder that will not be needed for the remainder of the print and run the rest of the print as a single-extruder job (disabling dual extruder options like ooze shields and priming towers above that point).
The text was updated successfully, but these errors were encountered:
It should be a checkbox to make it optional 'on'. I want it on.
Even tho my nozzles are level, it still hits the printed project, when it is hot it does not knock the printed material off the table.
Even if I switch to the other nozzle, then the other nozzle hits, its not a leveling problem, its the fact the the material beads up a little and because nozzle is hot it melts it instead of bumping it.
@whosawhatsis commented on Sun Nov 23 2014
The slicer should not only be smart enough not to heat an extruder that will not be used (as all others do), but it should also be smart enough to begin cooling down an extruder that will not be needed for the remainder of the print and run the rest of the print as a single-extruder job (disabling dual extruder options like ooze shields and priming towers above that point).
The text was updated successfully, but these errors were encountered: