Xplane Datarefs as config items require start/stop to populate

[aesellars]

Xplane Source Datarefs as config items require start/stop to populate. if an output is configured with an Xplane dataref value as it's source, and mobiflight is set to autorun, the values do not load and show 0 as output value. Starting and stopping the run is required to get them to read and populate

Steps To Reproduce
Load Mobiflight with the following output config:
Sim Variable -
X-Plane Dataref
Customized or preset code
sim/aircraft/controls/acf_RSC_redline_prp[0]
Enabled autorun
Save and Close Mobiflight
Open X-plane
Begin a new flight with the Van's RV-12
Sim running, and engine running
Open Mobiflight
Navigate to the output tab
Note the Flight Sim Value and Output Value are 0 (should read the dataref value but doesn't)
Press Stop
Press Start
Not the correct Flight Sim Value and output Value are now displayed
screenshots attached

Expected behavior
Mobflight would load and populate the sim dataref values on startup/autorun, when the sim is already running and aircraft is loaded.

Actual behavior
Mobflight is not loading/reading the values on startup/autorun and requires a stop/start to populate them

Details

• MobiFlight Version: 10.5.2 build 20250116
• FlightSim: Xplane 12.1.3-r2 build 121313 Intel 64-bit
• AddOn: Default Vans RV-10