Sometimes broken work effects after boot

[CLAM01]

What happened?

In some cases, effects do not play properly after a reboot or starting WLED.
Only if you e.g. If you call up the “LED prefereces” configuration page and simply click “save”, the effects will be played cleanly.

How does it affect?
If I e.g. sineon, the LEDs are not controlled properly and look like the photo on the left. If I then restart again or call up the LED preferences or a preset, then it suddenly works.

This affects ESP32 and ES8266.

To Reproduce Bug

Start WLED an set Effets to Sineon.
If the effect is ok, restart WLED until the Effect is not OK an save LED prefereces.

Expected Behavior

Effects works fine.

Install Method

From MoonModules Release Page

What version/release of MM WLED?

WLEDMM_0.14.1-b32.40_esp32_4MB_M AND WLEDMM_0.14.1-b32.40_esp8266_4MB_M

Which microcontroller/board are you seeing the problem on?

ESP32, ESP8266

Relevant log/trace output

No response

Anything else?

No response

Code of Conduct

• I agree to follow this project's Code of Conduct

[CLAM01]

Ok, i try to reinstall the WLED latest version on ESP8266.
Maybe there are disturbing artifacts because I really configured the entire WLED wildly and also made downgrades via the UI.

[CLAM01]

OK, so far everything is OK after a clean reinstallation of all WLEDs.

Ok, it's in my nature as a product owner to ruin everything somehow :-)

I'm closing this now too.

[CLAM01]

OK, after a time without voltage and restart the wleds with esp8266, the same effect. It's a bug? What do you need to analyse?