You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Tentative plans for default (and optional) settings for BLOM/iHAMOCC towards NorESM2.5
BLOM code refactorization
hybrid coordinates (default) (isopycnal optional)
only mks (default) (remove cgs dependencies)
Add 1/2 degree grid resolution
Add 2 degree grid resolution
Test all model configurations with NUOPC coupler
Apply existing higher order vertical reconstruction for the remapping of diagnostic fields on to reference depths (hybrid coord. only, reconstruction does not exist for isopycnic coord.)
Cold start of preformed (silicate) tracer - handle all preformed tracers equally - refer to Initialization of preformed tracers #356 for the provision of climatologies of preformed tracers. Clean-up of restart option for preformed silicate (currently checks, if prefsilicate is present, which could be removed)
@TomasTorsvik@matsbn@JorgSchwinger@jmaerz - some of these tasks will no longer be needed once we use the new stream functionality in BLOM. In particular you will not need separate datasets for 2 degree and 1/2 degree. I hope to start implementing this next week. We had decided to move ahead with the 1/2 degree using the older approach since simulations were going to being very soon and we did not want the new implementation holding up the science. However, I hope to have this in place so that we don't need to generate new datasets for 2 degrees and then hopefully move all the resolutions to just interpolation from the original source. At least that is what I think that @matsbn was leaning towards.
Tentative plans for default (and optional) settings for BLOM/iHAMOCC towards NorESM2.5
iHAMOCC-specific
kwrbioz
and enable POC remin above #365 and Hamocc kwrbioz off - enable remin and primary prod throughout full water column #367prefsilicate
is present, which could be removed)cime_config/config_component.xml
)The text was updated successfully, but these errors were encountered: