Inpaint using Fooocus model possible? #35
-
I remember some say we could use Fooocus Inpaint model in the original Forge, but never tried it. 1. Could someone tell if this is possible. 3. I must load the models in Controlnet Inpaint or like a normal model? Thx. |
Beta Was this translation helpful? Give feedback.
Replies: 1 comment 1 reply
-
I think it is possible. You should download the latest inpaint_v26.fooocus.patch and then put it in the controlnet folder. After that you go into inpaint section on the general tabs in img2img then controlnet. Click the inpaint section in the controlnet and find your model if it is not there click the refresh button to the right to find it manually from the all controlnet models there. However there are inpainting models for sdxl in civitai. Recently I started using the dreamshaper one. You can inpaint decently for 8 - 10 steps. |
Beta Was this translation helpful? Give feedback.
I think it is possible. You should download the latest inpaint_v26.fooocus.patch and then put it in the controlnet folder. After that you go into inpaint section on the general tabs in img2img then controlnet. Click the inpaint section in the controlnet and find your model if it is not there click the refresh button to the right to find it manually from the all controlnet models there. However there are inpainting models for sdxl in civitai. Recently I started using the dreamshaper one. You can inpaint decently for 8 - 10 steps.