-
Notifications
You must be signed in to change notification settings - Fork 2
/
ReadMe.txt
281 lines (217 loc) · 10.2 KB
/
ReadMe.txt
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159
160
161
162
163
164
165
166
167
168
169
170
171
172
173
174
175
176
177
178
179
180
181
182
183
184
185
186
187
188
189
190
191
192
193
194
195
196
197
198
199
200
201
202
203
204
205
206
207
208
209
210
211
212
213
214
215
216
217
218
219
220
221
222
223
224
225
226
227
228
229
230
231
232
233
234
235
236
237
238
239
240
241
242
243
244
245
246
247
248
249
250
251
252
253
254
255
256
257
258
259
260
261
262
263
264
265
266
267
268
269
270
271
272
273
274
275
276
277
278
279
280
Armor Rating Redux 2.0.6 SE
by DaJay42 on NexusMods.com
===============================================================================
Armor Rating Redux - No Cap, Better Formula, Morrowind-like
Fixes the ridiculously broken armor rating system in Skyrim by implementing a
formula closer to what Morrowind had. Fully configurable!
Now for SE!
===============================================================================
------------
The Problem:
------------
The vanilla armor system is utterly, utterly broken.
Having an armor rating of 0 - 300 is pretty much pointless, as you still take
almost full damage.
Having an armor rating of 300 - 600 suddenly means every point is valuable,
as your survivability increases hyperbolically.
Having an armor rating of over 667 (567 if in full armor) means any further
increase is pointless, as your damage resistance simply goes flat.
For a more detailed discussion, see this six years old(!) forum thread:
http://forums.nexusmods.com/index.php?/topic/481577-skyrims-armor-system-is-broken/
===============================================================================
-------------
The Solution:
-------------
Replace the broken system with one like in Morrowind, where every point of
armor counts.
This mod attempts to do just that.
It replaces Skyrim's Damage Resistance calculation with one of 3 formulas,
as described below. All of them can be fine-tuned in the mod's MCM, which
also has some advanced options for that really specific armor formula you
never knew you needed.
All changes apply to both the player and any NPCs.
Additionally, the mod provides two (optional) ways of informing the player of
their current resistance: by notification or with a (fake) magic effect.
===============================================================================
-----------
Definitions:
-----------
To make sure we're talking about the same thing, let's first define some terms:
Armor Rating: The current armor value displayed in your inventory, as
modified by your skills, perks, etc.
Hidden Armor Rating: On top of its visible armor rating, every piece of
armor you wear grants an additional 25 points of fixed, invisible armor
rating. This seems to be the result of a halfhearted attempt by Bethesda
to balance their broken system. This completely messes up the balance when
using armors with more than the standard amount of pieces.
Damage Resist(ance): The fraction of incoming damage that is negated by your
armor.
Damage Taken: The fraction of incoming damage that passes through your armor.
Survivability: By how much your armor increases your ability to survive damage.
e.g. with +400% survivability and 100 health, you could take 500 damage
before dying.
Level-Adjusted Survivability: By how much your armor increases your ability
to survive damage, relative to how much damage your enemies of the same
level can deal. In Skyrim, weapon damage increases linearly with skill,
so you need to have at least a linear increase in survivability to stay
ahead of the curve.
===============================================================================
---------
Formulas:
---------
The mod currently supports 3 computation modes:
-----------
Hyperbolic:
-----------
Morrowind-like. Every point of armor rating increases your survivability by a
fixed percentage. This means every point of armor is worth the same. Compared
to vanilla, your early armor will protect you a lot more, while armor past
the cap will still be useful, but it is difficult to reach crazy high
protection values.
HypDiv controls the increase per point. The default is 0.6%, which means you
will reach 80% protection (+400% survivability) at 667 armor rating, just like
vanilla.
Your survivability will increase linearly, damage taken decrease hyperbolically.
Twice the armor rating means twice the survivability.
Damage Taken = Input damage / (Armor Rating * HypDiv + 1)
------------
Exponential:
------------
A compromise between Morrowind-style survivability and vanilla "balancing".
Every point of armor will reduce damage taken by a fixed multiplier.
Your early armor will be worth less than with "Hyperbolic", but your late game
armor will let you come closer to 100% resistance.
ExpBase controls the damage multiplier per point. The default is 99.76%, which
means you will reach 80% protection (+400% survivability) at approximately 667
armor rating, just like vanilla.
Your survivability will increase exponentially, damage taken decrease
exponentially. Every 'x' points of Armor Rating, your survivability doubles.
Damage Taken = Input damage * ExpBase^Armor Rating
-------
Linear:
-------
Vanilla-like, but without the hidden armor rating. Just because.
Every point of armor reduces damage taken by subtracting a fixed value.
Results as described above.
LinearMult controls the reduction per point. The default is 0.12%.
LinearFloor controls the lowest possible multiplier. The default is 0.2
The default values let you reach 80% protection (+400% survivability) at
667 armor rating, just like vanilla.
Your survivability will increase hyperbolically, damage taken decrease
linearly.
Damage Taken = Input damage * max(LinearFloor, 1 - LinearMult * Armor Rating)
===============================================================================
-----------------
Advanced Options:
-----------------
As of 1.1.0, these advanced options are available:
FloorExpHyp: If activated, imposes a hard limit on your resistance in Hyperbolic
or Exponential modes, equivalent to what linearFloor does in Linear mode.
MultExpHyp: If enabled, reduces your resistance in Hyperbolic or Exponential
modes by a multiplier, acting as a soft ceiling.
Thanks Neker07 for the ideas!
===============================================================================
------------
Compability:
------------
- Should be loaded after other mods that change Game Settings related to
Armor.
- Not compatible with any mod that attempts to do the same thing (duh).
Compatible with everything else.
...probably.
===============================================================================
--------
Caveats:
--------
- The magic effect description will round resistance to the next integer
value. To know your precise resistance, use the "notify" option.
===============================================================================
Requirements:
- SKSE 2.0.17
- SkyUI SE
===============================================================================
--------
Changes:
--------
2.0.8 (SE only)
- Fixed issue with MCM menu not loading on new saves.
- Thanks to SSyl for the assistance!
2.0.7 (SE only)
- Updated for SKSE 2.0.17 / Runtime 1.5.97
- Changed display of Damage Taken text on options screen to percentage instead of decimals.
- Thanks to SSyl for the assistance!
2.0.6 (SE only)
- Updated for SKSE 2.0.16 / Runtime 1.5.80
- Thanks to SSyl for the assistance!
2.0.5 (SE only)
- Updated for SKSE 2.0.15 / Runtime 1.5.73
- Thanks to SSyl for the assistance!
2.0.4 (SE only)
- Updated for SKSE 2.0.11 / Runtime 1.5.62
2.0.3 (SE only)
- Updated for SKSE 2.0.9
2.0.2 (SE only)
- Updated for SKSE 2.0.8
2.0.1 (SE only)
- Fixed an oversight in the SE plugin that could cause actors with negative
armor rating to take infinite or negative damage if hyperbolic mode is
active.
2.0.0
- Complete overhaul of the mod's internals. Now does its computation in a
SKSE plugin, rather than Papyrus code. (A HUGE thank you to
underthesky for letting me make use of his SKSE code!)
Due to this being a huge change to the mods workings, a clean save
is absolutely recommended.
This change has some neat effects:
- Significantly increased performance.
- Player Only version no longer required, as calculations for NPCs are no
longer a potential performance drain.
- Changes in armor rating always have immediate effect.
- No more ActorValue or AVI Skill Mult caused incompatibilities.
- High Damage Resist values no longer cause weird stamina consumption
on blocking NPCs.
- NPC Damage Resist is no longer hard capped.
- On a different note, made the mod translation-friendly. Note that all
included translation files are dummy files and contain English text.
- Added a German translation to serve as an example. Translators for other
languages welcome!
1.2.1
- Fixed an issue that could cause the player to take excessive amounts of
damage when exceeding vanilla resistance limits.
1.2.0
- Changed the used actor value from "Fame" to "Variable07". This should
hopefully create less conflicts.
- Changed the way NPCs are treated. The new method has a hard cap at 99%
resistance, and might be slightly slower to update, but should be a lot
more reliable and cause less "spikes" in script activity.
- Added a "player only" version, for those who value performance over
fairness. A clean save is recommended when switching between
"Everyone" and "Player Only" versions.
1.1.0
- Added advanced options: If activated, FloorExpHyp imposes a hard limit on
your resistance in Hyperbolic or Exponential modes, equivalent to what
linearFloor does in Linear mode. MultExpHyp, if enabled, reduces your
resistance by a multiplier, and acts as a soft ceiling.
Thanks Neker07 for the ideas!
1.0.1
- Fixed minor issue that caused incorrect debug output.
1.0.0
- Initial release.
===============================================================================
----------------------------
Permissions/License/Credits:
----------------------------
The SE version of the mod contains code by locerra, without whom this port
would not have been possible. Many thanks!
Additional assistance was provided by hotemup. Thanks to you, too!
Update 1.0.5 was done in part by SSyl. Thanks!
The original mod contains code from Armor Rating Rescaled by underthesky:
http://www.nexusmods.com/skyrim/mods/85358/
Used under permission as stated on that mod's page.
(Once again, a huge thank you for that!)
Written by DaJay42, nexusmods.com, 2016-2019.
Software provided as-is, with no warranty.
For personal use only.
Re-uploads, uploads to other sites or uploads of derivative works are allowed
only after advance written permission by the author, or failure of the author
to respond within an month of a written request for such permission.