Skip to content

Latest commit

 

History

History
52 lines (39 loc) · 2.57 KB

udev.md

File metadata and controls

52 lines (39 loc) · 2.57 KB
Raw
title layout installation description
Linux udev Rules
onecolumn
active
Notes on creating udev rules in Linux

{{page.title}}

Linux assigns device names sequentially to hotplug hardware. Usually, your device will get the same name each time you connect it or boot your computer, but sometimes the name may change. For this reason, disks and partitions are typically referenced by UUID and not by device path any more. For our purposes dealing with USB serial adapters, the assigned device name is typically /dev/ttyUSB0. However, if you have more than adapter the device names may not always be consistent. Therefore, it is a good idea to create a udev rule to provide an alias for your device.

The example below assumes Debian or Ubuntu as the distribution, but it should be similar for others.

First, we need to collect some identifiers for the device we want to alias. In a shell, run the usb-devices command.

$ usb-devices

This will enumerate all of the USB devices connected to your computer (including internal USB hubs). In our example, we're looking for Actisense devices. Write down the Vendor, ProdId and SerialNumber values for each of your devices.

Then, in your favorite text editor, create a file in /etc/udev/rules.d/ called 90-actisense.rules. The 90 ensures that it processed after other udev rules.

The contents of the file should be:

SUBSYSTEMS=="usb", ATTRS{idVendor}=="0403", ATTRS{idProduct}=="d9aa", ATTRS{serial}=="1B091", SYMLINK+="actisense"

Replace 0403 with the value you wrote down for Vendor (if you are working with and Actisense device, it will likely be the same). Replace d9aa with the value you wrote down for ProdId and replace 1B091 with the value you wrote down for SerialNumber. The last change is to give your symlink a name. In the example above it is actisense, but you can call it whatever you want (without spaces or filesystems-reserved characters like /). Let's say you have two USG-1 devices, one for the autopilot and one for your VHF radio. You might want to name these devices autopilot and vhf. Then they would be available at /dev/autopilot and /dev/vhf respectively.

You can specify multiple rules in one file, one rule per line:

SUBSYSTEMS=="usb", ATTRS{idVendor}=="0403", ATTRS{idProduct}=="d9aa", ATTRS{serial}=="1B091", SYMLINK+="autopilot"
SUBSYSTEMS=="usb", ATTRS{idVendor}=="0403", ATTRS{idProduct}=="d9aa", ATTRS{serial}=="1B094", SYMLINK+="vhf"

After creating this file, disconnect your devices and plug them back in. You should see the new entries under /dev. If not, reboot.