watch-mode.md

Watch mode

Translations: Français, Italiano, Русский, 简体中文

AVA comes with an intelligent watch mode. It watches for files to change and runs just those tests that are affected.

Running tests with watch mode enabled

You can enable watch mode using the --watch or -w flags. If you have installed AVA globally:

$ ava --watch

If you've configured it in your package.json like this:

{
	"scripts": {
		"test": "ava"
	}
}

You can run:

$ npm test -- --watch

You could also set up a special script:

{
	"scripts": {
		"test": "ava",
		"watch:test": "ava --watch"
	}
}

And then use:

$ npm run watch:test

Finally you could configure AVA to always run in watch mode by setting the watch key in the ava section of your package.json, or ava.config.* file.

package.json:

{
	"ava": {
		"watch": true
	}
}

Please note that the TAP reporter is unavailable when using watch mode.

Requirements

AVA uses chokidar as the file watcher. Note that even if you see warnings about optional dependencies failing during install, it will still work fine. Please refer to the Install Troubleshooting section of chokidar documentation for how to resolve the installation problems with chokidar.

Ignoring changes

By default AVA watches for changes to all files, except for those with a .snap.md extension, ava.config.* and files in certain directories as provided by the ignore-by-default package.

You can configure additional patterns for files to ignore in the ava section of your package.json, or ava.config.* file, using the ignoredByWatcher key.

If your tests write to disk they may trigger the watcher to rerun your tests. Configuring additional ignore patterns helps avoid this.

Dependency tracking

AVA tracks which source files your test files depend on. If you change such a dependency only the test file that depends on it will be rerun. AVA will rerun all tests if it cannot determine which test file depends on the changed source file.

Dependency tracking works for required modules. Custom extensions and transpilers are supported, provided you added them in your package.json or ava.config.* file, and not from inside your test file. Files accessed using the fs module are not tracked.

Watch mode and the .only modifier

The .only modifier disables watch mode's dependency tracking algorithm. When a change is made, all .only tests will be rerun, regardless of whether the test depends on the changed file.

Watch mode and CI

If you run AVA in your CI with watch mode, the execution will exit with an error (Error : Watch mode is not available in CI, as it prevents AVA from terminating.). AVA will not run with the --watch (-w) option in CI, because CI processes should terminate, and with the --watch option, AVA will never terminate.

Manually rerunning all tests

You can quickly rerun all tests by typing r on the console, followed by Enter.

Updating snapshots

You can update failing snapshots by typing u on the console, followed by Enter.

Debugging

Sometimes watch mode does something surprising like rerunning all tests when you thought only a single test would be run. To see its reasoning you can enable a debug mode. This will work best with the verbose reporter:

$ DEBUG=ava:watcher npm test -- --watch --verbose

On Windows use:

$ set DEBUG=ava:watcher
$ npm test -- --watch --verbose

Help us make watch mode better

Watch mode is relatively new and there might be some rough edges. Please report any issues you encounter. Thanks!