-
-
Notifications
You must be signed in to change notification settings - Fork 162
Frame
Rac edited this page Dec 24, 2021
·
5 revisions
Following is a guide on how to build a frame from scratch. You can skip this part if you already have a Tronxy X5* frame.
The frame is connected via blind joints. Nero 3D has a good informational video about them:
-
Tap M5 threads for I and V type or M6 threads into the end of all 4020 alumuminium profiles.
-
Drill clearance at the end of all 2020 aluminium profiles facing the same direction for each profile.
-
Screw in the button head screws in all tapped holes, so that they are not fully screwed in by about 3 mm.
-
Assemble the frame as in the following picture
https://vzbot.org/ - VzBot 3D-printer community