The AES algorithm is a commonly used symmetric-key encryption algorithm, meaning that the same key is used for both encrypting and decrypting the data. The input and output data blocks for the AES algorithm are 16-bytes blocks (128-bits). AES has three key length types: 128-bit, 192-bit, and 256-bit. Before the AES encryption and encryption operation, an operation called key-expansion must be run when a key is given. The AES algorithm includes lots of bit-wise and byte-wise operations, so it is very suitable to be implemented with the hardware accelerator.
In applications, AES has five widely used usage models:
- Electronic codebook (ECB)
- Cipher block chaining (CBC)
- Cipher feedback (CFB)
- Output feedback (OFB)
- Counter (CTR)
In this tutorial, you only involve ECB and CBC. The following figures provide explanations for these models.
NOTE: Figures are from Wikipedia.
The RTL module Aes
is the core module of AES encryption/decryption module. It uses native RTL ports interface. You can find the Verilog source code in the ~/aes/rtl
directory. The signal descriptions are as follows.
Name | Width (bits) | Direction | Description |
---|---|---|---|
CLK | 1 | in | Clock input |
RESETn | 1 | in | Active-low reset input |
DATA_INPUT | 128 | in | Input data block for encryption or decryption |
KEY | 256 | in | AES key for encryption or decryption, when using 128/192 bit key, aligned to MSB (complement 0s to least significant bit (LSB) |
DATA_OUTPUT | 128 | out | Output data block for encryption or decryption |
NK | 2 | in | AES Key length: 2'b00=128bit, 2'b01=192bit, 2'b10=256bit |
NR | 4 | in | Reserved, tie to 4'b0000 for common AES operation |
START_CIPHER | 1 | in | When given one cycle active high trigger, cipher operation is executed (encryption or decryption). |
START_KEYEXP | 1 | in | When given one cycle active high trigger, AES key expansion operation is executed. |
OP_FINISH | 1 | out | When the encryption or decryption job is in progress, OP_FINISH will keep low. OP_FINISH will keep high in idle state. |
EXP_FINISH | 1 | output | When the key expansion job is in progress, EXP_FINISH will keep low. EXP_FINISH will keep high in idle state. |
A simple native Verilog testbench is provided in the ~/aes/tbench
directory. The testbench uses a pre-generated random dataset by a Perl script as the stimulus, and the output result is compared with the reference dataset generated by the OpenSSL utility. The shell script ~/aes/runsim_aes_xsim.sh
is used to generate the input stimulus and output reference and to run the simulation with Vivado XSIM.
A Makefile is provided here to run the simulation. Use following command to run the Verilog simulation:
cd ~/aes
make runsim
The simulation is executed with 256 input words (128-bit) along with pre-defined KEY. You can modify the simulation options in the ~/aes/runsim_aes_xsim.sh
file. After simulation finishes, a waveform dump file called work.tb_aes.wdb
is generated, in which you can view the interface waveform. The following image shows an example interface waveform.
Now that you have the necessary information about the Aes module, you can start to add the necessary AXI interfaces and IPs to make it a usable kernel for the Vitis flow. This is described in the next section: RTL Kernel: krnl_aes.
Copyright © 2020–2023 Advanced Micro Devices, Inc