Independence Test does not display results for selected variables only

[ibalaur]

Hello,
When I run Independence Test and load initially all variables, after which I selected several of them and run the test, I get results for all variables and not only for those selected.
If I add specifically each variable (one-by-one), everything works very well, the test is calculated and results are displayed only for these variables.
Could you please advise? Thank you. Please see below steps that I made:

Use HM instance
Run Independence Test (from Analytics)
Target: Diag_Group
Loaded all variables, selecting only 2 variables for performing the analysis/ exploration
Pressed Launch -> calculation is shown for all variables, not for the selected once only
Expected to have calculation only for the selected variables
Obs: It works for selected variables (as expected) when only those are loaded specifically (and not selected from the entire list)

[sherzinger]

@LBolzani If you need help with the statics please let me know