H32 Aquila-Sprite-BLT

[bigmick110]

Hi,
Is there an Aquila-Sprite-BLT build for the "H2" chipset ? Your thoughts :- I have a new N32 Aquila board.....Am I better off swapping this in and taking out my H32, which has never given me any troubles ??

[classicrocker883]

I did not make one for the Spite, I could though, however there are still a couple small issues w/H32.

for sure you're better swapping it out

[MontanaVike]

I also have the same build (H32 with sprite and BLT) but cannot find a firmware that works. Is this a lost cause? I'm wondering if I should just remove my BLT and stick with manual mesh.

[classicrocker883]

there is a connector that allows you to connect the probe, right? because some H32 boards like for the C2 does not have this 5-pin port.

if you have that connector, you should be able to use _UBL or _BLT version from here.

the only thing which may make it hard to use with a Sprite is the temperature. you might be able to swap the thermistor out with a stock or similar, but if not, the temp readings wont be accurate.

I couldn't tell you exactly how different right now, you could look up the thermistors temp table in the source code and compare the values and adjust yours accordingly.
Marlin\src\module\thermistor\thermistor_1.h
Marlin\src\module\thermistor\thermistor_13.h

thats what you can do for now, otherwise in the next release I can upload a file having Sprite support.

[MontanaVike]

I was trying to use the BLT connector on the Sprite. I didn't run it all the way to the motherboard. It seems to at least partially work because it will deploy/stow probe. It just won't stop the head from crashing into the bed if you try to level, auto-home, etc.