Creality Ender 3 S1 board type #145
-
|
Hey hivemind, I just got a S1 for a steal and want to add the PROUI to the unit. The problem is there is no chip type info that I can find. According to what I can find there is only 1 board type but it does not give the chip version. Any ideas where I might be able to find it or what board type firmware to use? |
Beta Was this translation helpful? Give feedback.
Replies: 3 comments 8 replies
-
|
It is likely to be a N32 chip but could be also be a H32 or G32, to be sure you will have to physically check it to confirm. Just turn the printer on its side and remove the bottom cover so you can see the ID of the chip. |
Beta Was this translation helpful? Give feedback.
-
|
Mik, I have a dumb question. I've downloaded the firmware placed it in the STM32F4_UPDATE folder and attempted update. It doesn't do a thing. I can flash back to the stock 3.04c firmware it's fine. Am I doing something wrong? |
Beta Was this translation helpful? Give feedback.
-
|
Looking again at that picture it is not a board I am familiar with On those boards it loads the .bin file from the "firmware" folder not a STM32F4_UPDATE folder. Are you sure it is a S1 and not something like an Aries or D1? |
Beta Was this translation helpful? Give feedback.
-
|
It's a creality ender S1 not aquila |
Beta Was this translation helpful? Give feedback.
-
|
This repository is mainly for the Aquila so probably won't work on the Ender S1 board with the builds available. I think this is what you need https://github.com/mriscoc/Ender3V2S1 |
Beta Was this translation helpful? Give feedback.
-
|
I appreciate it, thanks Mik. |
Beta Was this translation helpful? Give feedback.
-
|
Your chip is STM32F401 - I actually Do Not have this firmware yet available, that is next on the list to create. However, you can always compile your own firmware with the right config files. Actually that is what I will need, the correct configurations in order to create the firmware .bin files for this chip. @DarthDravenx if you'd like continue using MRiscoC's for now, but come back soon, I should have some firmware for this specifically. |
Beta Was this translation helpful? Give feedback.
-
|
@DarthDravenx added firmware files for Ender-3 S1 here |
Beta Was this translation helpful? Give feedback.
-
|
You rock, thanks! Don't suppose you have anything for a Sunlu S8 Pro do you? |
Beta Was this translation helpful? Give feedback.
Your chip is STM32F401 - I actually Do Not have this firmware yet available, that is next on the list to create.
However, you can always compile your own firmware with the right config files.
Actually that is what I will need, the correct configurations in order to create the firmware .bin files for this chip.
@DarthDravenx if you'd like continue using MRiscoC's for now, but come back soon, I should have some firmware for this specifically.