-
Notifications
You must be signed in to change notification settings - Fork 0
/
Copy pathLicense.txt
49 lines (39 loc) · 3.4 KB
/
License.txt
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
=====================================================================================================================================
RFLINK RAW INJECTOR LICENSE v1.0
=====================================================================================================================================
Arduino project "RFLink Raw Injector"
© Copyright 2020 Marc RIVES
Documentation : https://github.com/couin3/RFLink_Raw_Injector
Questions/Suggestions etc. mail to : [email protected]
Compiler : https://www.arduino.cc/ ; https://platformio.org/
=====================================================================================================================================
LICENSE TERMS AND CONDITIONS
The RFLink Raw Injector distributed code is made available free of charge and without any warranties.
This License explicitly affirms your unlimited permission to run the unmodified Program.
If someone made you pay for this program, contact us!
You are not allowed to sell the pre-compiled code or the source code or distribute it without this license file.
Usage of any parts of this code in a commercial work is prohibited unless express written approval is granted!
Some parts of the code might contain watermarking to identify our work.
You are not allowed to decompile, disassemble or reverse engineer any parts of the pre-compiled program.
The license does not permit incorporating this program into proprietary programs.
Disclaimer of Warranty.
This program is distributed in the hope that it will be useful, but WITHOUT ANY WARRANTY;
The copyright holders provide the program "AS IS" without warranty of any kind, either expressed or implied, including, but not limited to,
the implied warranties of merchantability or fitness for a particular purpose. The entire risk as to the quality and performance of the program
is with you. Should the program prove defective, you assume the cost of all necessary servicing, repair or correction.
Limitation of Liability.
In no event unless required by applicable law or agreed to in writing will any copyright holder, or any other party who modifies and/or conveys
the program as permitted above, be liable to you for damages, including any general, special, incidental or consequential damages arising out of the
ues or inability to use the program (including but not limited to loss of data being rendered inaccurate or losses sustained by you or third
parties or a failure of the program to operate with any other programs), even if such holder or other party has been advised of the possibility of
such damages.
-------------------------------------------------------------------------------------------------------------------------------------
Warning:
The RFLink Raw Injector should not be used in any life-threatening situations.
-------------------------------------------------------------------------------------------------------------------------------------
Installation information:
All files should be located in a directory named "RFLink_Raw_Injector".
Install the Arduino compiler. You can download the compiler at www.arduino.cc
Prefered is 1.8.10 or similar
Open from the Arduino IDE the file RFLink_Raw_Injector.ino
-------------------------------------------------------------------------------------------------------------------------------------