You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
I just got an M3D on a loan from a friend.
It prints ok-ish from it's windows client.
Now, I Downloaded Octopi and added the M33-fio plugin.
It connect to the printer and all, i can manually control it (turn the heater up, and extrude some filament) but when i try to print, the temprature goes up to the requested one which is 210 (or 215 ) and doesn't start to print even though it reached that temprature, everythign is stuck and i need to manually shut down the printer and reconnect.
I tried using the iMe firmware at first, and also the M3d one (that the windows version of the officla software installed afterwards)
how do i debug this?
The text was updated successfully, but these errors were encountered:
I just got an M3D on a loan from a friend.
It prints ok-ish from it's windows client.
Now, I Downloaded Octopi and added the M33-fio plugin.
It connect to the printer and all, i can manually control it (turn the heater up, and extrude some filament) but when i try to print, the temprature goes up to the requested one which is 210 (or 215 ) and doesn't start to print even though it reached that temprature, everythign is stuck and i need to manually shut down the printer and reconnect.
I tried using the iMe firmware at first, and also the M3d one (that the windows version of the officla software installed afterwards)
how do i debug this?
The text was updated successfully, but these errors were encountered: