Skip to content

Latest commit

 

History

History
45 lines (27 loc) · 3.14 KB

nrf52-radio-using-hal.md

File metadata and controls

45 lines (27 loc) · 3.14 KB
Raw

Using a Hardware Abstraction Layer

✅ Open the nrf52-code/radio-app/src/bin/led.rs file.

You'll see that it initializes your board using the dk crate:

let board = dk::init().unwrap();

This grants you access to the board's peripherals, like its LEDs.

The dk crate / library is a Board Support Package (BSP) tailored to this workshop to make accessing the peripherals used in this workshop extra seamless. You can find its source code at nrf52-code/boards/dk/src/.

dk is based on the nrf52840-hal crate, which is a Hardware Abstraction Layer (HAL) over the nRF52840 System on Chip. The purpose of a HAL is to abstract away the device-specific details of the hardware, for example registers, and instead expose a higher level API more suitable for application development.

The dk::init function we have been calling in all programs initializes a few of the nRF52840 peripherals and returns a Board structure that provides access to those peripherals. We'll first look at the Leds API.

✅ Run the led program. Two of the green LEDs on the board should turn on; the other two should stay off.

NOTE this program will not terminate itself. Within VS code you need to click "Kill terminal" (garbage bin icon) in the bottom panel to terminate it.

✅ Open the documentation for the dk crate by running the following command from the nrf52-code/radio-app folder:

cargo doc -p dk --open

✅ Check the API docs of the Led abstraction. Change the led program, so that the bottom two LEDs are turned on, and the top two are turned off.

🔎 If you want to see logs from Led API of the dk Board Support Package, flash the dk with the following environment variable:

DEFMT_LOG=trace cargo run --bin led

The logs will appear on your console, as the output of cargo run. Among the logs you'll find the line "I/O pins have been configured for digital output". At this point the electrical pins of the nRF52840 microcontroller have been configured to drive the 4 LEDs on the board.

After the dk::init logs you'll find logs about the Led API. As the logs indicate, an LED becomes active when the output of the pin is a logical zero, which is also referred as the "low" state. This "active low" configuration does not apply to all boards: it depends on how the pins have been wired to the LEDs. You should refer to the board documentation to find out which pins are connected to LEDs and whether "active low" or "active high" applies to it.

🔎 When writing your own embedded project, you can implement your own BSP similar to dk, or use the matching HAL crate for your chip directly. Check out awesome-embedded-rust if there's a BSP for the board you want to use, or a HAL crate for the chip you'd like to use.