diff --git a/source/_integrations/snoo.markdown b/source/_integrations/snoo.markdown
new file mode 100644
index 000000000000..6eebc0867707
--- /dev/null
+++ b/source/_integrations/snoo.markdown
@@ -0,0 +1,58 @@
+---
+title: Snoo
+description: Instructions on how to integrate Snoos into Home Assistant
+ha_category:
+  - Sensor
+ha_iot_class: Cloud Push
+ha_release: 2025.2
+ha_config_flow: true
+ha_codeowners:
+  - '@Lash-L'
+ha_domain: snoo
+ha_platforms:
+  - sensor
+ha_integration_type: integration
+---
+
+The Snoo is a smart bassinet that helps get your baby to sleep and helps keep them asleep.
+
+
+## Installing the integration
+This integration follows standard integration installation. No extra steps are required.
+
+{% include integrations/config_flow.md %}
+
+## Sensors
+
+### State
+
+The Snoo can have one of 8 states
+1. Baseline - This is the basic state the snoo starts with. It has not detected the need to do any further soothing.
+2. Level 1 - This is the lowest level of soothing
+3. Level 2
+4. Level 3
+5. Level 4
+6. Stop - The snoo is no longer running
+7. Pre-timeout - the snoo is preparing to go back to stop rotating
+8. Timeout - the snoo is stopping rotating.
+
+### Last Event
+The snoo will send a message whenever a event occurs. This entity displays the last event that was sent. There are 9 possible events
+1. Activity button - The activity button was pressed
+2. Timer - A timer has started, and once the timer ends, it will go down a level.
+3. Power Button - The power button has been pressed.
+4. Cry - The snoo detected your baby is crying.
+5. Command - A command was sent to the Snoo
+6. Safety clip - A safety clip was either attached or detached.
+7. Long activity press - The activity button was long pressed.
+8. Restart - The Snoo was requested to restart.
+9. Initial status requested - The status was requested at the beginning of a session.
+
+## Time left
+This describes how long until the Snoo will change levels or it is -1 if it is not currently planning to change levels.
+
+## Removing the integration
+
+This integration follows standard integration removal. No extra steps arerequired.
+
+{% include integrations/remove_device_service.md %}