Print does not correspond to settings!

[maxx92]

Drucken Version 1.2a, pivCCU 2.31.25

When I print the settings of my floor heating controller, the printout shows under "interval for decalcification run" not active but under settings it is set to 1 day! So there is a discrepancy between settings and printout. Where does the printout get its data then from?

[HMside]

You're using a HmIP-FAL? Please make a screenshot and mark what settings you mean.

[maxx92]

Sorry for my late reply. I was on vacation.

[bytecarousel]

The issue is still there!
Running the latest addon 2.4 on Raspberrymatic 3.61.7.20211218 and Browser MS Edge.
Settings of direct link printout are not the real settings on the CCU, please resolve the
issue or add an comment on istallation to check printout before archiving the document.

(direct-link) HmIP-SMO-A <-> HmIP-FDT
Settings on CCU3:

Printout with addon:

(direct-link) HmIP-WRC6 <-> HmIP-FSM16

CCU3:

printout: