DAIKIN64 Protocol issue with power toggle when changes are applied to integration

[orthobots]

Hi there!

Thanks a lot for all your work on this integration.
I'm having an issue where my Daikin unit that runs off the DAIKIN64 protocol constantly goes out of sync.
The reported state of the remote vs the actual state of the HVAC becomes inverted after a while, or after a power cycle.
That usually results in mode adjustments or temperature adjustments on the integration causing the HVAC to turn off, while applying the new settings; turning it back on via remote causes the integration to turn off instead.

I noticed this being mentioned in #47 , and subsequently resolved, and i'm not sure how it was resolved, or if it was reintroduced later.

[nao-pon]

@orthobots You can check the IR signal on the Tasmota web console. Can you perform some operations and provide the console results?