Replies: 5 comments 4 replies
-
The question is whether you purchased a cathode or anode variant of the LED 😉 ./Klaas |
Beta Was this translation helpful? Give feedback.
-
Is the bulb looking bit on this the bit you should put over the flashing LED on the electric meter? I just stuck that over the LED with some gaffer tape to test it. Don't think its working. Do I need to adjust that pot on it? |
Beta Was this translation helpful? Give feedback.
-
As you can see, they're the other side of the wall from each other, so that's a bit of a pain. |
Beta Was this translation helpful? Give feedback.
-
Is the LED on the smaller board with the photodiode supposed to flash when it gets a red pulse? It seems to be lit up green solid. Then there's a red LED on the main board in the garage, and that also seems to always be on. |
Beta Was this translation helpful? Give feedback.
-
Hi,
I flashed the software to the device as shown in the instructions (had to use Chrome on Linux, Brave wouldn't work).
It booted okay, and I bound it to my WIFI and added to Home Assistant.
However, I tried wiring the LED on, and it doesn't work. Have I bought the right things?
https://www.aliexpress.com/item/1005003302215339.html?spm=a2g0o.order_list.order_list_main.30.3f421802s75pWA
https://www.aliexpress.com/item/4000225253691.html?spm=a2g0o.order_list.order_list_main.40.3f421802s75pWA
https://www.aliexpress.com/item/1005005970816555.html?spm=a2g0o.order_list.order_list_main.35.3f421802s75pWA
Not tried the Diode yet, as ran out of connector leads :)
Beta Was this translation helpful? Give feedback.
All reactions