How to view/set the presets via MQTT?

[forTT78]

Hi together,
i would like to ask if can see and change some presets (like beep, display, windfree) via MQTT, is there a way?
E.g. activate/deactivate windfree?

Via MQTT I see for eg. the swing_mode but not if windfree is active or not.

May be someone has a hint for me.

best regards,
Thomas

[Oggy123]

Hi Thomas, yes, it's possible. You can control them in topic climate/unit_name/preset/command, but first you have enable it in yaml section capabilities -> presets

[forTT78]

Nice! Thank you. I will try it.
Is there a list of all available presets?

[Oggy123]

From example.yaml:

The following modes are available: sleep, quiet, fast, longreach, windfree

[forTT78]

Hmm, ok. I was looking for something what I use on the remote under options:
like "beep off", "display off" - is these kind of setting also a preset?

[Oggy123]

It's been discussed in another topic, these options are probably not published on the bus. AFAIK even with original modbus card you can't modify these options. For me is best combination this project (for reading current states) and ESPEasy with IRremoteESP8266 (for sending commands, because it's possible control beep and display).