| layout | title |
|---|---|
documentation |
EBV-105 - ZWave |
{% include base.html %}
This describes the Z-Wave device EBV-105, manufactured by EcoNet Controls with the thing type UID of econet_ebv105_00_000.
The device is in the category of Valve, defining Valves used to control water or gas. e.g. a flow stop valve..
The EBV-105 supports routing. This allows the device to communicate using other routing enabled devices as intermediate routers. This device is also able to participate in the routing of data between other devices in the mesh network.
Wireless z-wave water shutoff controller, prevent water damage.
The EBV105 water shutoff controller is easy to install and configure. No special tools or plumbing required. The included clamp supports installation.
You need to add a water leak sensor.
Place the Z-Wave controller in pairing (learning) mode. Press the SET/Power button 3 or more times rapidly (within 0.5 seconds).
Place your Z-Wave controller in exclusion (un-learning) mode. Once the controller is in exclusion mode, bring the EBV105 close to the Z-Wave controller (several feet) and press the Power button 3 or more time rapidly (within 0.5 seconds).
The following table summarises the channels available for the EBV-105 -:
| Channel Name | Channel ID | Channel Type | Category | Item Type |
|---|---|---|---|---|
| Switch | switch_binary | switch_binary | Switch | Switch |
Switch the power on and off.
The switch_binary channel is of type switch_binary and supports the Switch item and is in the Switch category.
The device has no configuration parameters defined.
Association groups allow the device to send unsolicited reports to the controller, or other devices in the network. Using association groups can allow you to eliminate polling, providing instant feedback of a device state change without unnecessary network traffic.
The EBV-105 supports 1 association group.
Association group 1 supports 5 nodes.
| Command Class | Comment |
|---|---|
| COMMAND_CLASS_NO_OPERATION_V1 | |
| COMMAND_CLASS_BASIC_V1 | |
| COMMAND_CLASS_SWITCH_BINARY_V1 | Linked to BASIC |
| COMMAND_CLASS_SWITCH_ALL_V1 | |
| COMMAND_CLASS_MANUFACTURER_SPECIFIC_V1 | |
| COMMAND_CLASS_ASSOCIATION_V1 | |
| COMMAND_CLASS_VERSION_V1 |
Did you spot an error in the above definition or want to improve the content? You can contribute to the database here.