You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
I'm setting up alarm server in my hikvision NVR but I'm facing a problem:
Control Panel ask me several info. First of all the protocol (HIKVISION,OPTEX,GJD,Luminate) and depending of the protocol selected I have to specify username and password. I'm confused because I was expecting only address, port and nothing more. I'm using IOT channel Settings -> Alarm Device -> New device
I was trying to use HA interface to add the alarm device but i gave me an ISAPI ERROR so I'm trying to set it up by myself via hikvision web interface.
any Ideas ?
Thank You
The text was updated successfully, but these errors were encountered:
Thank you fort your answer; the link was very useful. It took me some days to verify my configuration and I got the wrong point of my configuration. I'm going to report it to help anybody else with same issue:
There was two errors:
1: in my hikvision nvr configuration ( DS-7608NI-I2 / 8P) I had both input alarm and output alarm set up. ISAPI error disappears when I choose "Manual alarm" in Output alarm tab.
2: My Input alarm was misconfigured and has been configured with: N.C. (normally closed) and handling mode: Disabled
In my HA I was using the wrong value as automation input. the right event is "When XYX starts detecting motion" ( I was using "Motion activated" that is another kind of event).
The Alarm server in my NVR is located under : Network -> Advanced configuration -> Other
I'm setting up alarm server in my hikvision NVR but I'm facing a problem:
Control Panel ask me several info. First of all the protocol (HIKVISION,OPTEX,GJD,Luminate) and depending of the protocol selected I have to specify username and password. I'm confused because I was expecting only address, port and nothing more. I'm using IOT channel Settings -> Alarm Device -> New device
I was trying to use HA interface to add the alarm device but i gave me an ISAPI ERROR so I'm trying to set it up by myself via hikvision web interface.
any Ideas ?
Thank You
The text was updated successfully, but these errors were encountered: