-
Camera AXIS Q6074 I tried using 「ptremotecalibration/start.cgi」, but the response is Status Not Found. |
Beta Was this translation helpful? Give feedback.
Replies: 3 comments 4 replies
-
This automatically generated reply acts as a friendly reminder. Answers to your questions will most often come from the community, from developers like yourself. You will, from time to time, find that Axis employees answers some of the questions, but this is not a guarantee. Think of the discussion forum as a complement to other support channels, not a replacement to any of them. If your question remains unanswered for a period of time, please revisit it to see whether it can be improved by following the guidelines listed in Axis support guidelines. |
Beta Was this translation helpful? Give feedback.
-
For current PTZ camera, after camera reboot, it will go to Home preset. If you hope to control that in your own program, you can save it as a preset and then control to run the calibration, then recall the previous preset. the calibation cgi should be : GET /axis-cgi/com/ptz.cgi?auxiliary=reset |
Beta Was this translation helpful? Give feedback.
-
Thank you for your reply. I realized this using the CGI commands you taught me. appreciate. The calibration will take a little longer, but it can't be helped. |
Beta Was this translation helpful? Give feedback.
For current PTZ camera, after camera reboot, it will go to Home preset.
If you hope to control that in your own program, you can save it as a preset and then control to run the calibration, then recall the previous preset.
the calibation cgi should be : GET /axis-cgi/com/ptz.cgi?auxiliary=reset