PolarFire-SoC
GUI of Renode is not launching #147
-
|
[WARNING] Couldn't start UI - falling back to telnet mode |
Beta Was this translation helpful? Give feedback.
Replies: 3 comments 5 replies
-
|
Sorry I never had this issue, so I do not have direct answer with a solution. My suspition is that when you run the Then if you could run this If the output will be empty or listing just few packages then probably I'm wrong, but if the output will be very long with a lots of packages then that could be a indication or maybe even a cause of all sorts of issues. I have many years ago a one Debian installation which was using heavily 32-bit packages on a 64-bit OS and it was cause of all sorts of troubles. |
Beta Was this translation helpful? Give feedback.
-
|
Another thing you could try is to run Renode directly (not from SoftConsole) just to rule out any SoftConsole influence. |
Beta Was this translation helpful? Give feedback.
-
|
https://github.com/renode/renode/blob/master/README.rst#installation From the above link installed renode and dependency , GUI is coming now. |
Beta Was this translation helpful? Give feedback.
-
|
Yes the |
Beta Was this translation helpful? Give feedback.
-
|
I don't know if this helps, but I already encountered this message when I was running Renode manually on WSL-2. |
Beta Was this translation helpful? Give feedback.
-
|
On WSL you have very stripped distributions compared to interactive GUI desktop installs which are bloated with packages. For that case I would see WSL almost on-par with docker containers. For example here is a debian based container and installing packages needed for Renode: https://github.com/AntonKrug/docker-images/blob/master/softconsole-base-slim/Dockerfile#L29-L43 |
Beta Was this translation helpful? Give feedback.
-
|
The GH multi-line highlighting sometimes work, sometimes doesn't. I was highlighting lines 29 to 43. |
Beta Was this translation helpful? Give feedback.
-
|
Hi AntonKrug , not sure which 32 bit one is creating problem |
Beta Was this translation helpful? Give feedback.
Sorry I never had this issue, so I do not have direct answer with a solution.
But this is just my speculation, maybe you have some package missing which is needed for the GUI.
It might be installed as its own 32-bit variant, so for some applications it might ok and present, while for some (renode/mono) it might not be present. I notice the warning before in the previous issue that you might have installed some 32-bit libs.
For that probably you added the 32-bit architecture to yours at some point in the past (with a command like this
dpkg --add-architecture i386, do not run it, i'm just listing it here to see if it will ring any bell)My suspition is that when you run the
dpkg --print-arc…