output board
output-board features eight 10A relays and four 0-10V proportional outputs, making this board really suitable to control loads wirelessly.
Relays are rated for AC mains use but you should only consider connecting relay outputs to mains if you really have the necessary skills and experience. Mains voltage can kill so proceed at your own risk.
This version of output-board works better with panStamp NRG since the AVR module can not drive relays 5 and 6 from A6 and A7.
- Power supply: 12VDC.
- 8 x Relays: 10A @ 230VAC, 7 with NO and NC contacts and 1 with NC contact
- 4 x 0-10V outputs: low-current control signals.
- Status LED for each relay.
- Optional footprint for through-hole SMA connector
- Optional enclosure
The shield includes a real time IC (Maxim DS1338) with battery backup so that we don't depend on remote NTP servers and Internet connections to get the current time, even after a power outage.
The shield needs a panStamp programmed with either binouts or binouts2.