You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
#include<Arduino.h>// the setup function runs once when you press reset or power the boardvoidsetup () {
// initialize digital pin LED_BUILTIN as an output.pinMode (LED_BUILTIN, OUTPUT);
}
// the loop function runs over and over again forevervoidloop () {
digitalWrite (LED_BUILTIN, HIGH); // turn the LED on (HIGH is the voltage level)delay (1000); // wait for a seconddigitalWrite (LED_BUILTIN, LOW); // turn the LED off by making the voltage LOWdelay (1000); // wait for a second
}
I can fine upload and run it blink.cpp and others
Debug starts and breaks at setup
Call Stack "dump"
setup @ 0x10000902 (c:\Users\hs\Documents\PlatformIO\Projects\RP2040_1\src\main.cpp: 6)
@ 0x60582020 (Unknown Source: 0)
Data from DEBUG CONSOLE
If I put BreakPoint in the loop it stops Sometimes once) I almost never, if i make a manual break after a while
DEBUG CONSOLE after Break manual pause
Debugger Segger J-LINK EDU
platformio.ini
test code
Please see
https://community.platformio.org/t/debug-pico-rp2040-some-who-have-success-with-it/25865/2
KR Henrik
The text was updated successfully, but these errors were encountered: