Code to control a Portal Gun (From Rick and Morty)
##Libraries Download and install the following libraries:
If you deviate from the following definitions, you will have to change the firmware to account for that.
| LED Display | Trinket Pro Pin |
|---|---|
| SCL | A5 |
| SDA | A4 |
| GND | GND |
| Vcc | 5V |
| Vi2c | 5V |
| Rotary Encoder | Trinket Pro Pin |
|---|---|
| A | A1 |
| B | A0 |
| GND | GND |
| Button | A2 |
| LED | Trinket Pro Pin |
|---|---|
| Top Bulb | 9 |
| Front Right | 3 |
| Front Center | 5 |
| Front Left | 6 |
First, set up the Arduino IDE according to Adafruit. Connect your Trinket Pro and make sure the bootloader is running, then click upload.
The rotary encoder has a click button, and we can detect a single click, a double click, and a hold.
- Single Click : Wakes the Trinket Pro from low power mode
- Double Click : Reset to dimension C137
- Hold : Turn off LEDs and put the Trinket Pro into a low power mode.
##Installing SFX The main branch doesn't have SFX support. Use the SFX branch to test this out (I found that the speaker inside the case was too quiet to hear.)