diff --git a/docs/simulation/security/index.md b/docs/simulation/security/index.md
index 8209612700c..0cae59ed915 100644
--- a/docs/simulation/security/index.md
+++ b/docs/simulation/security/index.md
@@ -58,17 +58,19 @@ connected to a given bus bar section.
 
 Remedial actions are actions that are applied when limit violations occur. Supported actions are:
 
-- Open or close a switch
-- Open or close a terminal
-- Change the tap of a tap changer (phase or ratio)
-- Change the active and/or reactive power of a load (by setting the values, or defining changes in value or percentage)
-- Change the section of a shunt compensator
-- Change the regulation status of a tap changer
-- Change `targetP`, `targetQ`, regulation status and `targetV` of a generator
-- Change the regulation mode of a static var compensator and its associated set point.
-- Enabled or disabled AC emulation for HVDC line (with the possibility to change `P0` and `droop` for AC emulation and
+- `LoadAction` Change the relative of absolute `P0` and/or `Q0` of a load
+- `DanglingLineAction` Change the relative of absolute `P0` and/or `Q0` of a dangling line
+- `SwitchAction` Open or close a switch
+- `TerminalsConnectionAction` Open or close a terminal
+- Change the tap of a tap changer (phase `PhaseTapChangerTapPositionAction` or ratio `RatioTapChangerTapPositionAction`)
+- `PercentChangeLoadAction` Change the active and/or reactive power of a load (by setting the values, or defining changes in value or percentage)
+- `ShuntCompensatorPositionAction` Change the section of a shunt compensator
+- Change the regulation status of a tap changer (phase `PhaseTapChangerRegulationAction` or ratio `RatioTapChangerRegulationAction`)
+- `GeneratorAction` Change `targetP`, `targetQ`, regulation status and `targetV` of a generator
+- `StaticVarCompensatorAction` Change the regulation mode of a static var compensator and its associated set point.
+- `HvdcAction` Enabled or disabled AC emulation for HVDC line (with the possibility to change `P0` and `droop` for AC emulation and
   active power set point and converter mode for set point operating mode)
-- Change the interchange target of an area by specifying a new interchange target in MW.
+- `AreaInterchangeTargetAction` Change the interchange target of an area by specifying a new interchange target in MW.
 
 Remedial actions can be *preventive* or *curative*:
 
@@ -77,6 +79,8 @@ Remedial actions can be *preventive* or *curative*:
 - curative: these actions are implemented after a violation occurs, for example, if the flow of the monitored line is
   greater than `100%`.
 
+Note: you can find the current list of remedial actions implemented in the PowSyBl Open Load Flow security analysis provider in the [PowSyBl Open Load Flow documentation](inv:powsyblopenloadflow:*:*#security/inputs).
+
 ### Conditions
 
 Actions are applied if a condition is met. The conditions can be diversified and extended in the future: