More of a request than an issue

[malcinator]

Would it be possible to add a menu to the CW1/CW1S to be able to select user configure run time?

I first was my prints in IPA for 2 minuets (depending on the Resin Manufactures Guide). Then I like to wash it in clean water for 10 minuets at a much slower speed. Then I set about drying it and curing it. The curing I have set to two minuets but the drying I have set a longer period. Depending on the size of the print depends on the drying & curing combination

Having to keep remembering to change the times, speeds, drying & curing settings for each of my Resins, washing, drying etc. combinations is very time consuming. Having a user configurable run time menu would be a huge feature to add to the CW1 and save a whole lot of frustration and time.

Maybe you could consider this option as I feel it would be a fantastic feature to add?

[tritol]

I have an idea of "configuration preferences" - all settings can be switched using a single menu. It should be useful for various resins and it could solve your use case too. However, there is a limit to the size of the device processor code and the lack of my time :-(.

[malcinator]

Ah. That is somewhat disappointing for such a premium piece of Hardware. But I completely understand that you are all busy. I am also busy and being able to shave off just a minuet or two per print would be welcome. It may even allow me time for an extra mug of tea.

Please keep this request and your 'Idea' on the table as I feel it would be a great benefit to have. My fingers are crossed, tightly.