You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Hi!
Currently, there's an option to fill only small holes, i.e., holes that have only a maximum number of boundary edges. It would be cool to have a more general option to specifically select a hole. A start would be to have a similar method to Basic_TMesh::fillSmallBoundaries() that would make the check grd == nbe instead of grd <= nbe. This would ensure that only those holes with a specific number of boundary edges are filled. To avoid any kind of ambiguities, an option to specify the indices of the boundary would be best.
The text was updated successfully, but these errors were encountered:
Hi!
Currently, there's an option to fill only small holes, i.e., holes that have only a maximum number of boundary edges. It would be cool to have a more general option to specifically select a hole. A start would be to have a similar method to
Basic_TMesh::fillSmallBoundaries()
that would make the checkgrd == nbe
instead ofgrd <= nbe
. This would ensure that only those holes with a specific number of boundary edges are filled. To avoid any kind of ambiguities, an option to specify the indices of the boundary would be best.The text was updated successfully, but these errors were encountered: