We are going to make a robot that beeps and has a flashing antenna using a Raspberry Pi.
As well as a Raspberry Pi and the usual peripherals you'll also need:
- 1 x LED
- 1 x 220 ohm resistor
- 4 x Female-to-female jumper wires
If you are running Raspbian Wheezy you'll need:
- The Latest version of Scratch (with GPIO support)
If you are running Raspbian Jessie then The latest version of scratch is included.
An SD card loaded with Raspbian Jessie will not require any additional software.
- 1 x paper clip
Unless otherwise specified, everything in this repository is covered by the following licence:
Robot Antenna by the Raspberry Pi Foundation is licenced under a Creative Commons Attribution 4.0 International Licence.
Based on a work at https://github.com/raspberrypilearning/robot-antenna