Time Circuits Wall Clock

Here are a few photos of my custom Time Circuits Wall Clock.

Final result:

The clock replaced a failing QLOCKTWO so I made it the exact same size, 40x40cm (15.75x15.75in).

The body is made from wood; the front is a 6.5mm (0.25in) plywood panel, the rest is made from birch, resulting is a very low weight.

As for the 3D-printed parts: The three enclosures were glued together using industrial duct tape, with an offset of about 1cm (0.4in) to make the clock not too deep. On the back, I cut out space for the control board.