You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
{{ message }}
This repository has been archived by the owner on Nov 19, 2020. It is now read-only.
I attached both temperature sensor and extnernal bistable switch to sonoff basic.
If bistable switch is ON (loop closed = GND is connected to GPIO1), then after powering off sonoff it won't start, no led blinking, no wifi presence, nothing or works very unstable (very slowly loads part of configuration page).
After changing the circuit to open and replugging sonoff, it starts normally.
If I use GPIO sonoff works "boots up" always, regardless external switch state.
this is rather minor problem, greetings
The text was updated successfully, but these errors were encountered:
Hello,
I attached both temperature sensor and extnernal bistable switch to sonoff basic.
If bistable switch is ON (loop closed = GND is connected to GPIO1), then after powering off sonoff it won't start, no led blinking, no wifi presence, nothing or works very unstable (very slowly loads part of configuration page).
After changing the circuit to open and replugging sonoff, it starts normally.
If I use GPIO sonoff works "boots up" always, regardless external switch state.
this is rather minor problem, greetings
The text was updated successfully, but these errors were encountered: