Alarm Control Panel Stuck in Entry-Delay / Pending #774
-
Hi all, I seem to be experiencing an issue where my Alarm Control Panel device is stuck in the state of Pending due to the AlarmState perpetually being reported as entry-delay. I have tried arming and disarming the alarm multiple times to clear the status with no luck. Note that the status is showing correctly in the Ring application. I have also reconfigured the keypad in the Ring application and rebooted the base station and Home Assistant, again to no avail. This issue has occurred previously but somehow resolved itself, this doesn't seem to be the case on this occasion. Looking at the MQTT messages, the device in Home Assistant is indeed reflecting the MQTT messages correctly. I am currently driving my heating schedule automations based on whether our house is occupied or not (using the Alarm Control Panel status as a proxy for this). I would really appreciate if you have any suggestions for resolving this recurring issue? |
Beta Was this translation helpful? Give feedback.
Replies: 2 comments 1 reply
-
Did you try restarting the addon (not restarting HA, the specifically the addon)? |
Beta Was this translation helpful? Give feedback.
-
Resolved |
Beta Was this translation helpful? Give feedback.
Did you try restarting the addon (not restarting HA, the specifically the addon)?