Wifimanager AP doesnt show up

[epictechlab]

Hi there,

I'm struggled with the orginal Code from "Everythingsmarthome" so i've desided to give your fork a try.
I've flashed your code on my Wemos D1 mini. Which works flawlessly. But the Wifimanager AP doesn't show up. I've tested it with 3 Phones and 1 PC. but i Cant find the AP.

I've been searching through your Code where i cant put my Wifi and mqtt Parameters in.
I'm new to Wifimanager.h so i can't find the right lines.
Can you give me a hint?

Best regards

[epictechlab]

The Serial Monitor shows:

WM (I assume its WifiManager) config is incorrect. could cause AP doesnt show up.

[vinz486]

Hi,
can you try to reset?

[Zappelphilipp]

seems like i do have the same problem flasing my wemos d1 works but then no AP shows up. tried 2 differend wemos boards.

console output just says:

load 0x4010f000, len 3460, room 16 
tail 4
chksum 0xcc
load 0x3fff20b8, len 40, room 4 
tail 4
chksum 0xc9
csum 0xc9
v0005c8a0
~ld

EDIT:
never mind, i did two things wrong:

• i made a little solder bridge between two pins
• i did not connect the sensor during boot up