Hatched copperfill very different when comparing v6 and v7

[set-soft]

I don't know if this is a bad thing, but I prefer to maintain things the same, unless something is wrong.

For a test case I have the following using KiKit 1.3.0 and KiCad 6.0.11:

But with the same parameters and using KiCad 7.0.0 I get:

The most annoying thing is copper going to the border of the PCB. I know KiCad changed the way this is specified (no longer in the zones, now as a global setting). But this doesn't look good.

Then we have rotated hatch. Didn't investigate why.

I saw this problem when I tried to use the same reference image for the regression tests of KiBot.

[yaqwsx]

This is definitely an inconsistency between versions that is not wanted (both, orientation and margin from edges). I will have to look up the KiCAD source code if the default meaning of orientation was changed or not.