- Keyboard Maintainer: EPOMAKER
- Hardware Supported: EPOMAKER Split65
- Hardware Availability: EPOMAKER Split65
Make example for this keyboard (after setting up your build environment):
make leo/epomaker_split65:default
Flashing example for this keyboard:
make leo/epomaker_split65:default
To reset the board into bootloader mode, do one of the following:
- Hold the Reset switch mounted on the bottom side of the PCB while connecting the USB cable
- Hold the Escape key while connecting the USB cable (also erases persistent settings)
- Fn+R_Shift+Esc will reset the board to bootloader mode if you have flashed the default QMK keymap
See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.
Enter the bootloader in 3 ways:
- Bootmagic reset: Hold down the key at (0,0) in the matrix (usually the top left key or Escape) and plug in the keyboard
- Physical reset button: Briefly press the button on the back of the PCB - some may have pads you must short instead
- Keycode in layout: Press the key mapped to
QK_BOOTif it is available