H36 Combo V1 is a newly designed 125℃ high temperature tool board Based on STMG0B1T3.
Important
- Since there is no 125 degree Celsius USB-HUB chip, the 125 degree Celsius operating environment is limited to CANBUS mode；
- Klipper currently does not support 125 degree Celsius accelerometers, so the 125 degree Celsius operating environment does not include accelerometers. The default version of H36 is ADXL345, which has a maximum operating temperature of 85 degrees Celsius. The 105 degree Celsius ADXL345-EP version is optional, but it is more expensive.
V1.1
1.add Driver NTC
2.add 3.3V/5v monitor
3.add 24v monitor
-------------------------------------
V1.2
1.change to XT30
2.add reserve protection
3.fix can/usb indicate
-------------------------------------
V1.3 (Currently Available)
Note
V1.3 only makes hardware changes and does not affect any software configuration.
1.Add level_shift to FAN_TACH
2.Fix silk mark
3.Add jumper resistor from USB-C to STM32
4.ADXL345-EP optional
5.Change the LDO chip to TLV75733
6.New mass-produced cables（Mold Forming）