Skip to content

FrankBuss/beat707

Folders and files

NameName
Last commit message
Last commit date

Latest commit

 

History

51 Commits
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

Repository files navigation

Development environment

Programmer and debug connection

For programming you can use an USBasp. The red wire of the USBasp programmer needs to be connected to the pin 1 location:

Programmer

For debugging, there is the jumper J5 near the MIDI connector, to connect a 5V UART receiver. Connect the top pin to GND (black wire in the image) and the bottom pin to the UART RX input (grey wire) :

debug pin

Fuse programming

The Arduino IDE doesn't flash the ATmega fuses, so initially you need to do this from the command line with avrdude like this:

avrdude -cusbasp -p m328 -B 10 -U lfuse:w:0xff:m

The output should look like this:

avrdude: set SCK frequency to 93750 Hz
avrdude: AVR device initialized and ready to accept instructions

Reading | ################################################## | 100% 0.00s

avrdude: Device signature = 0x1e9514 (probably m328)
avrdude: reading input file "0xff"
avrdude: writing lfuse (1 bytes):

Writing | ################################################## | 100% 0.00s

avrdude: 1 bytes of lfuse written
avrdude: verifying lfuse memory against 0xff:
avrdude: load data lfuse data from input file 0xff:
avrdude: input file 0xff contains 1 bytes
avrdude: reading on-chip lfuse data:

Reading | ################################################## | 100% 0.00s

avrdude: verifying ...
avrdude: 1 bytes of lfuse verified

avrdude: safemode: Fuses OK (E:FF, H:D9, L:FF)

avrdude done.  Thank you.

Arduino IDE setup

First install the Arduino IDE. It was tested with Arduino 1.8.13. Then add the URL https://mcudude.github.io/MiniCore/package_MCUdude_MiniCore_index.json to "File->Preferences->Settings->Additional Board Manager URLs". Then you can install the new board with "Tools->Board->Boards Manager". Install "MiniCore by MCUdude", tested with version 2.1.0.

For programming you need an USBasp. You need to reduce the clock speed in the file /home/username/bin/arduino-1.8.9/hardware/arduino/avr/programmers.txt, where username is your username (on Linux, on Windows and Mac it might be different, see here). Search for the usbasp.program.extra_params line and add the parameter -B 10. The full line now looks like this:

usbasp.program.extra_params=-Pusb -B 10

Restart the Arduino IDE after changing it.

After restart, select the new board: Tools->Board->MiniCore->ATmega328. For flashing the firmware, configure the following settings (Board, Clock, Variant and Bootloader needs to be changed):

Arduino settings

Then select your programmer, for example USBasp:

Prorgammer settings

After this you can program the ATmega328 on the board from the Arduino IDE by clicking on the right arrow.

Releases

No releases published

Packages

No packages published

Contributors 4

  •  
  •  
  •  
  •